1999 Honda Accord clock light - EZ change

Discussion in 'Accord' started by sailnbob, Nov 30, 2003.

  1. sailnbob

    sailnbob Guest

    Just replaced the clock light on my 1999 Accord. Took all of 2
    minutes!
    The clock/flasher assembly pops out as one unit. You can use a
    screwdriver but be careful not to scratch the dash. I opted for a 1
    1/2" wide putty knife. Place tool in bottom middle of the
    clock/flasher and apply SLIGHT upward pressure and the assembly pops
    out. The light is on the right side when viewed from the front, left
    side viewed from the rear. The round 3/16" diameter plastic head is
    the bulb. Using a small screwdriver, turn 1/4 turn counter-clockwise
    to remove. Install new bulb with 1/4 turn clockwise. Turn on
    ignition switch to check for operation. (Light comes on with ignition
    switch not headlights.)

    Get the replacement bulb at your local dealer, part number
    35505-S84-B02.
    cost $3.19

    I have two local Honda dealers, one quoted me $45 labor and the other
    said the whole dash assembly needed to be removed, cost $80 labor!!!
    Wonder why dealerships have a lousy reputation?

    If you can change a lightbulb in your home, this has about the same
    level of difficulty.

    Bob
     
    sailnbob, Nov 30, 2003
    #1
  2. sailnbob

    mj Guest

    ..
    Thanks to all that replied - Easier than I ever imagined. Once you
    know the trick, it's quite easy.

    At first the bulb would turn, but it didn't come out easily. Since I
    wasn't sure what I was looking for, I was initially hesitant whether it
    was really the bulb, until you described it. That gave me confidence
    to pry it a little harder with the screwdriver. It then freed very easily.

    Thanks again to all. Saved me some $$.
     
    mj, Nov 30, 2003
    #2
  3. sailnbob

    BillW Guest

    That is interesting as the 99-04 service manual has you pull the whole dash
    out. That is why the dealer is quoting what he is.....
     
    BillW, Dec 1, 2003
    #3
  4. sailnbob

    SoCalMike Guest

    they just want to *charge* you to pull the dash out :)
     
    SoCalMike, Dec 2, 2003
    #4
  5. I don't know what manual you're looking at, but it's certainly not a
    Honda manual--because Honda changed the Accord to a brand-new, never
    seen before platform for the 03 model year.

    Any service manual that claims it's for the "99-04 Accord" is third
    party, and is obviously junk.
     
    Elmo P. Shagnasty, Dec 2, 2003
    #5
  6. sailnbob

    Bo Williams Guest

    Absurd. Take this to the bank: there is no genuine Honda documentation
    anywhere that says to pull the dash to replace the clock light bulb in a
    sixth-gen ('98-'02) Accord. I don't know what kind of squirrelly book
    you're looking at, but it ain't genuine Honda. As another poster
    pointed out, the year range includes two different generations--and they
    couldn't even get *that* right, because '98 should be included in the
    range as well.
     
    Bo Williams, Dec 2, 2003
    #6
  7. sailnbob

    Wade Punch Guest

    REMINDER: Be sure to unplug the wiring harness from the clock module
    first. I did not, when I was "helping" a friend. If you use a metal
    screwdriver to unscrew the bulb, it will touch the metal leads on the
    bulb and short it out.
    Avoid this problem by simply taking a few extra seconds to unplug the
    harness first.
    Also, I obtained the same exact part # from West Broad Honda dealer in
    Richmond; I call their toll free number, 800-446-0160, and they ship
    to me in TN. On a 10/20/03 invoice, the list price shown is $1.52 and
    they sold them to me for $1.11 @. Interesting your dealer charged you
    twice the list price!
    Where are you located? What dealer was it? I don't want to order from
    them.
    Wade
    Nashville TN
     
    Wade Punch, Dec 22, 2003
    #7
  8. sailnbob

    mj Guest

    Cost me $2.14 - at a local RI Honda dealer.
     
    mj, Dec 22, 2003
    #8
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.