86 CRX coolant filling problem

Discussion in 'General Motoring' started by Primetime2628, Jun 5, 2004.

  1. Primetime2628

    Primetime2628 Guest

    What is the correct procedure for filling the coolant on this car?
    It will run for a while and then start overheating. Usually when
    doing stop and go driving. I've tried venting, raising the front end
    on ramps and draining and filliing. No leaks apparent.
    Thankls in advance.

    {~._.~}
    ( Y ) Life is not measured by the number of breaths we take,
    ()~*~() but by the moments that take our breath away
    (_)-(_)
     
    Primetime2628, Jun 5, 2004
    #1
  2. Primetime2628

    N.E.Ohio Bob Guest

    Are you opening the little vent bleeder near the thermostat housing? I
    have a piece of plastic hose that fits over the end of the bleeder that
    I watch till coolant flows without bubbles. Put the other end of the
    hose in a small container to catch the run off.
     
    N.E.Ohio Bob, Jun 5, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. filling transmission oil

  2. Honda CRV loss of power after filling up - white smoke too

  3. honda coolant temps sensor problem - redux

  4. civic "coolant problem" redux

  5. Coolant loss problem: 92 Accord

  6. Coolant overheating problem

  7. can I mix a type 2 Honda coolant with traditional green coolant?

  8. 88 CRX si Coolant loss

Loading...