92 accord Error code

Discussion in 'Accord' started by D.L., Nov 12, 2003.

  1. D.L.

    D.L. Guest

    I have a 92 EX. I was getting a Error 43 code. So I did a "Complete"
    tuneup, wires,plugs fuel filter,ect.I replaced the 02 sensor, I also
    reset the computer by disconnecting the battery cables and removing
    the 7.5 fuse. Now, about 5 secs after starting i get a error 41 code,
    which is o2 sensor heater malfunction. I checked all connectionsWhat
    do I need to check now?? Thanks for any help.
    D.L.
     
    D.L., Nov 12, 2003
    #1
  2. D.L.

    Randolph Guest

    The heater is internal to the O2 sensor, and the only remedy is to
    replace the sensor. If it is the original sensor you have gotten about
    as much service out of it as you can expect.
     
    Randolph, Nov 12, 2003
    #2
  3. D.L.

    D.L. Guest

    Hi,
    Its a Brand New O2 sensor..
    DL



     
    D.L., Nov 13, 2003
    #3
  4. Heater circuit is part of the main relay, fuse, ECU, and the heater.
    First, check heater resistance. Then at the ECU and O2 connector, with
    ign. ON, measure

    Yel/blk + and Or/Blk -

    There should be voltage. Both supply heater power. I may be off, see
    flow chart go to:

    http://www.honda.co.uk/owner/AccordManual/424/6-10.pdf

    Rick
    West coast, CA
     
    Ricky Spartacus, Nov 14, 2003
    #4
  5. D.L.

    D.L. Guest

    When u start the car after its been sitting awhile, the Check engine
    comes on after about 5 seconds, But if you turn off the car and
    restart it, it never comes back on. Strange.
     
    D.L., Nov 24, 2003
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.