95 Civic LX Intake Air Temperature Sensor

I can't check the ignition timing, since the engine doesn't run. Is
there a way to check ignition timing without the engine running?
Thanks.

 

wrote in

Yeah, have someone crank while you test. Same as if it was running, but
cranking instead. Timing ought to be close to the specified 16deg BTDC.

Another method: Turn engine by hand to TDC compression (#1 valves closed),
then remove distributor cap and see if rotor arm is pointing at the #1
terminal on the cap. That will give you an idea whether the timing's
horribly off or not.

Are you sure your timing belt hasn't slipped?

 

wrote in

Yeah, have someone crank while you test. Same as if it was running, but
cranking instead. Timing ought to be close to the specified 16deg BTDC.

Another method: Turn engine by hand to TDC compression (#1 valves closed),
then remove distributor cap and see if rotor arm is pointing at the #1
terminal on the cap. That will give you an idea whether the timing's
horribly off or not.

Are you sure your timing belt hasn't slipped?

 

add:

wire cutters and wire strippers.

 

add:

wire cutters and wire strippers.

 

try autohausaz.com I bought a Walker O2S for 78.00 USD with free shipping.
Ordered Friday,received Monday,UPS Ground.

 

try autohausaz.com I bought a Walker O2S for 78.00 USD with free shipping.
Ordered Friday,received Monday,UPS Ground.

 

I bought a $10 metric socket/wrench and magnetic-bit screwdriver set from
Big Lots,it works great,except I had to junk and replace the ratchet.It
even has a needle-nose pliers.

 

I bought a $10 metric socket/wrench and magnetic-bit screwdriver set from
Big Lots,it works great,except I had to junk and replace the ratchet.It
even has a needle-nose pliers.

 

What I carry is the tookit from an older GoldWing motorcycle. It has
a very complete set of wrenches, sockets, etc. in a very nice leather
roll-up. I think they stopped including that tool kit in 1988. Well
worth it if you can find one.

Dick

 

The original was a Denso O2S,the Walker sensor had better insulation on the
wires,and the proper OEM connector.

 

The original was a Denso O2S,the Walker sensor had better insulation on the
wires,and the proper OEM connector.

 

Jim,

How long has this Walker been in use? Any problems?

 

Jim,

How long has this Walker been in use? Any problems?

 

I checked eBay, no luck on the GoldWing kit.

 

Only 5 days.

Not yet.

 

Only 5 days.

Not yet.