98 Accord - Removing the factory fitted stereo

Hi,

Anyone know an easy way to get the factory fitted stereo out of 1998 Honda
Accord Coupe

Any help would be much appreciated.

Regards
John

---------------------------------------------


Visit the ALL NEW site for MG & Rover Owners & Enthusiasts

Torque MG Rover

http://www.torquemgrover.com



Visit the ALL NEW site for Vauxhall Enthusiasts

Torque Vauxhall

http://www.torquevauxhall.com



Fancy a Laugh

Tears of Laughter has humour for all

http://www.tearsoflaughter.co.uk

 

"webmaster" <> decided to join the
conversation on 05 Oct 2003 with message

Check this out:

http://installdr.com/InstallDocs/Honda/PDF/466053.pdf

good luck!

--
-Chris

http://www.ChrisGarcia.com <- My Homepage
http://www.chrisgarcia.com/cars/ <- *NEW* My cars
http://www.chrisgarcia.com/dogs/ <- *Sort-of NEW* My dogs
http://starwars.chrisgarcia.com/ <- Centerpoint Station, the "ghost-
town" of the Star Wars Universe!

 

"webmaster" <> decided to join the
conversation on 05 Oct 2003 with message

Check this out:

http://installdr.com/InstallDocs/Honda/PDF/466053.pdf

good luck!

--
-Chris

http://www.ChrisGarcia.com <- My Homepage
http://www.chrisgarcia.com/cars/ <- *NEW* My cars
http://www.chrisgarcia.com/dogs/ <- *Sort-of NEW* My dogs
http://starwars.chrisgarcia.com/ <- Centerpoint Station, the "ghost-
town" of the Star Wars Universe!

 

See the tech section at http://www.autotoys.com/tech for lots of photos

 

Thanks for the help! Finally got it out.....cant believe they bolt the damn
thing in! Anyway now replaced with a lovely Sony Multichanger ;-)

Regards
John
----------------------------
Visit the all new site for Vauxhall Owners and Enthusiasts
Torque Vauxhall - http://www.torquevauxhall.com
Now includes GM Daewoo Forums!

Visit the all new site for MG & Rover Owners and Enthusiasts - Torque MG
Rover
http://www.torquemgrover.com

 

Crowbar.

 

Crowbar.

 

Start at the rear bumper.
Remove the tow hook cover, and anything else you fing between you and
the engine bay bulkhead.

 

Start at the rear bumper.
Remove the tow hook cover, and anything else you fing between you and
the engine bay bulkhead.

 

No no no, those are the instructions for an average heater-matrix

 

No no no, those are the instructions for an average heater-matrix

 

@news01.east.earthlink.net>, posted the
following drivel...
......In article <blpqd2$lto$>,
......
......> Anyone know an easy way to get the factory fitted stereo out of 1998Honda
......> Accord Coupe
......
......Crowbar.
......
several screws under the ashtray. remove them and the entire
faceplate over the radio and a/c vents will pull forward from
the bottom. be carful of the clips.
--

**:::::>>:§«:*?`³?³?`*:»§:<<:::::**
.·°~ §LëAzZ? WëA§ëL ~°·.
**:::::>>:§«:*?`³?³?`*:»§:<<:::::**

{ô¿ô} WrOnG NuMbEr RoCoCcO, yOu .·°~ §LëAzZ? WëA§ëL ~°·.

 

@news01.east.earthlink.net>, posted the
following drivel...
......In article <blpqd2$lto$>,
......
......> Anyone know an easy way to get the factory fitted stereo out of 1998Honda
......> Accord Coupe
......
......Crowbar.
......
several screws under the ashtray. remove them and the entire
faceplate over the radio and a/c vents will pull forward from
the bottom. be carful of the clips.
--

**:::::>>:§«:*?`³?³?`*:»§:<<:::::**
.·°~ §LëAzZ? WëA§ëL ~°·.
**:::::>>:§«:*?`³?³?`*:»§:<<:::::**

{ô¿ô} WrOnG NuMbEr RoCoCcO, yOu .·°~ §LëAzZ? WëA§ëL ~°·.

 

DANGER DANGER DANGER DANGER DANGER

Watch what you listen to on the net.

Two screws, running vertically underneath the bottom of the radio trim
panel.

Now: with a small screwdriver, gently pry out the clock from the
bottom. Disconnect it and put it aside. Behind the clock is the ALL
IMPORTANT THIRD SCREW. Take it out.

NOW you can pop out the radio trim panel, complete with climate
controls. Put a rag or two inside the clock cavity, get your fingers in
there as best you can, and yank. It's just pressure clips.

Remember: there are THREE screws, two down below and one up above
behind the clock.

 

DANGER DANGER DANGER DANGER DANGER

Watch what you listen to on the net.

Two screws, running vertically underneath the bottom of the radio trim
panel.

Now: with a small screwdriver, gently pry out the clock from the
bottom. Disconnect it and put it aside. Behind the clock is the ALL
IMPORTANT THIRD SCREW. Take it out.

NOW you can pop out the radio trim panel, complete with climate
controls. Put a rag or two inside the clock cavity, get your fingers in
there as best you can, and yank. It's just pressure clips.

Remember: there are THREE screws, two down below and one up above
behind the clock.

 

several screws under the ashtray. remove them and the entire

High voltage ?

And also what you read.

I think he was working on the basis that it's the same basic car as a
Rover 600...

 

several screws under the ashtray. remove them and the entire

High voltage ?

And also what you read.

I think he was working on the basis that it's the same basic car as a
Rover 600...

 

In which case, his instructions were bollocks

You have to remove the leccy window switches first. Then take off gearnob,
and remove entire centre console (one screw is under the leccy window
switches).
Once that is out of the way, the centre bit holding the stereo(s) can be
removed.

 

In which case, his instructions were bollocks

You have to remove the leccy window switches first. Then take off gearnob,
and remove entire centre console (one screw is under the leccy window
switches).
Once that is out of the way, the centre bit holding the stereo(s) can be
removed.

 

I think he was working on the basis that it's the same basic car as a

That's very big of you

<quick check>

oops, I misread it, I thought it was you that Elmo replied to, heh.