OK, my 95 Civic is a piece of cake to set the ignition timing, but my daughter's 98 (east coast)Civic, is very confusing? And, I have read multiple posts about shorting the connector and on the 98 there is only one two wire connector imbedded in a rubber plug near the top of the ECU. This 98 (maybe all 98's) is certified as meeting Federal and Calif emissions standards. Maybe, that is why there is no sticker under the hood that shows ignition timing? Again, I have the factory book for my 95, but only, the Haynes for the 98. It says to look for the sticker under the hood. There is a sticker that covers plugs, valve clearances, but not ignition timing. My plan was to just check the timing. I have reviewed over 500 posts on Civic Ignition Timing. Topic 8457 was quite interesting under Honda General, but there was confusion about the one (and only one)connector lighting the CEL. Also which of the three marks (not counting the fourth mark which is TDC)do you set the timing to? Thanks in advance for your assistance!