Accord 4cyl 5speed won't shift

Discussion in 'Accord' started by Zazoos, Apr 1, 2006.

  1. Zazoos

    Zazoos Guest

    Accord 4cyl 5speed won't shift. 124,000 miles

    The clutch slave cylinder was going out, so I purhcased a new Clutch
    Master Cylinder, Slave Cylinder and the line from Honda. I installed
    them and the car ran fine for about a week. The cylinders are holding
    pressure and fully extending the clutch arm. Now the car doesn't want
    to go into any gear. If I turn the car off, I can change gears, when
    the car is running and in gear with the clutch pressed to the floor the
    car doesn't leach forward or give signs of the cylinders slipping. I
    suspect the clutch disc is worn and needs replacing. What is your
    opinion.
     
    Zazoos, Apr 1, 2006
    #1
  2. Zazoos

    jim beam Guest

    sounds like the clutch diaphragm is sticking to the drive pinion so it
    won't release from the flywheel properly. may as well replace the
    clutch being as you have to disassemble to fix it. but before you do,
    bleed the hydraulic clutch system one more time to be certain there's no
    air in the system.
     
    jim beam, Apr 1, 2006
    #2
  3. Zazoos

    Zazoos Guest

    Problem Fixed,

    I adjusted the part that screws onto the clutch master cylinder and
    attaches to the clutch pedal. I'm not for sure why the clutch worked
    the first week and then didn't but after adjusting the part and giving
    the clutch master cylinder more travel the car shifts fine. Thanks for
    the help.

    Zazoos
     
    Zazoos, Apr 2, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.