Auto Trans 2000Civic SI low load shift not smooth

Discussion in 'Civic' started by Dave Austin, Jul 7, 2005.

  1. Dave Austin

    Dave Austin Guest

    In Jan 2005 I bought a CivicSI 2000 w/D16Y8 engine code with 187,000 km
    When I start cold and accelerate slowly (below 3000 rpm), and low load
    (by that I mean I try to slowly ease into 2nd & 3rd), I experience
    slight jump or jerk when trans shifts from 1st to 2nd, and 2nd to 3rd
    After about 5 to 10 minutes it is much smoother most of the time, bu
    not always. It hasn't gotten worse in 4 the months I've been aware i
    it. If I accelerate harder at cold start, it seems to shift smoother.
    A tech at the local dealer drove it after it warmed and couldn't se
    the problem. I have replaced the ATF with the Honda Trans fluid onc
    and no improvement. I have checked (w/oscilloscope &/or meter) the MA
    sensor, Temp Sensor, & TPS, all seem to change smoothly. (The MA
    voltage reads 1.09 V at cold idle.) I checked the PCV valve (seeme
    clogged) cleaned and replaced, but no change. I've changed oil & ai
    filters with no improvement.
    I don't want to believe that the trans is going bad but maybe that'
    all I can expect. Any ideas
     
    Dave Austin, Jul 7, 2005
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.