bal shaft seal

Discussion in 'General Motoring' started by Gene Wagenbreth, Nov 27, 2007.

  1. Gene Wagenbreth

    Gene Wagenbreth Guest

    1990 Honda Accord 4 cyl. Driving and oil pressure light flashes whenever
    I put on the brakes. Had it towed to a mechanic. He says balance shaft seal
    blew out. He is putting in new seal, with aftermarket retainer, along with
    timing belt and water pump.

    Comments ????

    G
     
    Gene Wagenbreth, Nov 27, 2007
    #1
  2. Gene Wagenbreth

    motsco_ Guest

    -----------------------

    The later Accord and Odyssey did it too:

    http://www.tegger.com/hondafaq/tsb/accord/index.html#accord There should
    have been LOTS of oil on the parking lot, No?

    'Curly'
     
    motsco_, Nov 27, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Civic Trans Input Shaft

  2. Balancer Shaft Seal Failure - Expert Advice Needed

  3. 1992 honda driver side cv drive shaft axle

  4. 95 Integra right half shaft replacement

  5. 92 Accord balance shaft seized

  6. How far in to press balance shaft seals on 2.2L Accord Motor?

  7. Balancer shaft seal replacement (92 Accord)

Loading...