Break/fuel lines?

Discussion in 'General Motoring' started by Forest, Dec 29, 2003.

  1. Forest

    Forest Guest

    Howdy, just got a call from my friendly mechanic working on my 2000 Civic
    DX, he says he noticed that the break and fuel line that run along chassis
    under a protective cover are damaged. Says that cover appears to have been
    hit by something and crimped/twisted lines. (I bought this car 2 months
    ago.) Anyway, says the lines from Honda cost $330 - this sound reasonable?

    Thanks...
     
    Forest, Dec 29, 2003
    #1
  2. Forest

    Mista Bone Guest

    sounds like the car was in a wreck and not properly repaired.
     
    Mista Bone, Dec 29, 2003
    #2
  3. I don't know about the price being reasonable but I would check out some
    online parts places if you know what lines they are.

    How damaged are they? Obviously you don't want to mess around with damaged
    brake or fuel lines but have you seen the damage?

    CaptainKrunch
     
    CaptainKrunch, Dec 29, 2003
    #3
  4. Forest

    Rex B Guest

    The lines themselves are cheap. in most cases. Probably represents 10-20% of
    that quote. That leaves $250-$300 for installation, which seems excessive unless
    replacement involves a lot of parts removal - which it normally does not.
    That figure represents 4 - 5 hours labor.


    |Howdy, just got a call from my friendly mechanic working on my 2000 Civic
    |DX, he says he noticed that the break and fuel line that run along chassis
    |under a protective cover are damaged. Says that cover appears to have been
    |hit by something and crimped/twisted lines. (I bought this car 2 months
    |ago.) Anyway, says the lines from Honda cost $330 - this sound reasonable?
    |
    |Thanks...
    |
    |

    Rex in Fort Worth
     
    Rex B, Dec 29, 2003
    #4
  5. Forest

    Forest Guest

    The $330 is just for the parts. Yes he showed the damage to me and yes it
    looks like the previous owner ran over something that tore up this one area
    a bit. He ordered the parts from Honda and will be in soon. Not gonna mess
    with the lines. Thanks for the feedback.
     
    Forest, Dec 29, 2003
    #5
  6. Forest

    Tegger® Guest


    You can easily cut off the damaged areas and splice in new generic line.
    Just need a flare tool and the correct ends. Your guy does not need to
    spend $330 of your money to do this.

    If the fuel line is a low pressure return you can use rubber hose and hose
    clamps.
     
    Tegger®, Dec 30, 2003
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.