Bridgestone RE 750's on a 2001 Prelude..Sweet!

Discussion in 'Prelude' started by O.Phooey, Apr 12, 2004.

  1. O.Phooey

    O.Phooey Guest

    My daughter borrowed my car and hit a chuck(pot)hole and took out one
    of my front OEM Bridgestone RE 92's with 27K miles. Still had almost
    half the tread left. This surprises me as the wear rating for the tire
    is 160. Actually the rating surprised me. I had no problems with these
    tires. Well, this sweet machine never quite handled as nimbly as my
    Integra (with Michelin xgtv's OEM), so here was the opportunity to see
    what this baby would do with better (ultra high performance) summer
    tires. I ended up buying 4 750's and an alignment. Wear rating, if it
    means anything at all, is 340. Now, this auto not only sticks to the
    road better on those 25mph curves at 50, but feels more sure and
    stable doing it. Sweet! As a matter of fact, I had to use more gas
    just to back out of the garage as the machine was almost stuck to the
    ground. Or could it be that Keira was playing with the hot glue gun
    again.
    Anyone else want to comment on their experience with these tires? I
    know they are not much for snow, but summer's coming. I can drive my
    Integra in the winter. If my daughter lets me.
     
    O.Phooey, Apr 12, 2004
    #1
  2. O.Phooey

    twaugh5 Guest

    I replaced my OEM R 92s on a 01 Prelude at 36k miles with the 750s and am
    extremely pleased with them at 40k now. Vastly improved wet weather
    handling and overall improved dry pavement handling. Still have not
    figured out what the tire pressure is supposed to be. The installer claimed
    I shoudl run them at the max rate 51 lbs. I have tried 45 and now 40. The
    latter appears to be a good compromise. Most of my driving is to and from
    work on I75 in mid GA running 80- 85. Could not tell you about snow --
    never see it.
     
    twaugh5, Apr 13, 2004
    #2
  3. O.Phooey

    O.Phooey Guest

    The tire pressure is another story. I'm use to running my tires at the
    car specs, or 2 to 3 lbs. higher. On the Prelude, about 32 psi (Honda
    recommended). I've replace tires on both my '91 Integra and 2001
    Prelude and in both cases, w/o asking me, Discount Tire had the
    Falkens at 38-40 psi. And when I asked the other tire dealer what they
    put the Bridgestone re 750's at he said 40 lbs. I mentioned this to
    the tech who put on the second set (4 tires at different times during
    the same week)and he was shocked and immediately lowered the first set
    to the same as the ones he'd put on. I've never run tires at 40 psi.
    They probably wear out faster, but may resist side wall damage better.
    I haven't had a flat in years, but have lost several tires, and some
    wheels, to sidewall damage from road debris or holes. I bought the
    tire warranties for the first time. Chuck holes be damned.....Of
    course they don't cover the other undamaged tire you replace for
    balance.
     
    O.Phooey, Apr 13, 2004
    #3
  4. O.Phooey

    dizzy Guest

    Ya, you betcha pilgrim. Welcome to the world of driving on
    high-quality tires. It's gooood.
     
    dizzy, Apr 14, 2004
    #4
  5. O.Phooey

    twaugh5 Guest

    I don't think the higher pressure will cause them to wear out sooner. Ran
    the R92s at 36 lbs and probably could made 40k miles before replacing. The
    wide range of pressures recommended by the "experts" bothers me. I am
    inclined to think that the factory recommended pressures still apply because
    they consider the weight and handling characteristics of the car.
     
    twaugh5, Apr 14, 2004
    #5
  6. O.Phooey

    mike Guest

    i finally replaced the OEM firestones on my 98 civic hatch. rock hard, a
    couple plugs in some of the tires, can o fixaflat in one, but still with
    half the tread left.

    went from the 185/65 14s to a set of BFGoodrich touring tires, 195/60 14.

    it feels like a brand new car now. guess i wont be getting that scion xA ive
    been wanting.
     
    mike, Apr 14, 2004
    #6
  7. O.Phooey

    Horseman Guest

    I'm seriously considering Bridgestone Turanza LS-T's for my '93 Accord LX.
    There are a lot of positive reviews for this tire on TireRack.com. Then
    again, I think any tire would be better than the horrible Uniroyal's that
    are on the car now.
     
    Horseman, Apr 14, 2004
    #7
  8. O.Phooey

    JM Guest

    The RE950's are no slouch either, even better at blending lots of good
    characteristics than the RE930's that they replaced. But,
    progressively noisy after the first half of tread is gone, so I just
    replaced them with Yokohama db's at 4/32". Well it's a quiet ride as
    Tirerack advertised, but responsiveness is much the poorer though not
    really unacceptable. Ride is much better too. The zoom has been
    taken out of the car. Though it still hangs on tenaciously around
    corners, it just isn't comfortable and reassuring. (a '96 I30t).

    I think the Yoko's can stand much more than the 29 psi factory
    recommended. But it is just compensation for the really soft
    sidewalls. Most tire companies will admit that the tire should be run
    at 2-3 psi more than the car company says. Car manufacturer is bias
    toward a good ride, tire company toward long tire life.

    As to the RE92's, keep in mind there are several variants of this tire
    all with the same name. Some are H rated, some T, some are OEM. My
    wife had OEM on a '96 Avalon when brand new. It was okay for a
    cruiser, but hardly a performance tire. (Nor did the handling tighten
    up much with RE930's later; the suspension just wasn't up to it.)

    JM
     
    JM, Apr 14, 2004
    #8
  9. O.Phooey

    twaugh5 Guest

    The RE 92 V rated on the Prelude were barely adequate. Lousy wet traction
    and dry not much better. Transitional response OK, but given the weak
    traction you could not trust them. Wore well though.
     
    twaugh5, Apr 15, 2004
    #9
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.