cd player speed?

Discussion in 'General Motoring' started by Mary Gaunt, Jan 18, 2006.

  1. Mary  Gaunt

    Mary Gaunt Guest

    2004 honda accord EXL equipped with 6 pack cd player (honda) in dash.
    Question: Playing duration seems longer as if the cd is rotating with
    revolution per minute resulting with slight reduction enjoyment(ie: music)
    In otherwords the effect sounds `draggy'. Is there a standard at which cd's
    are oppose to spin and can it be adjusted within this honda equipment?
    Thanks in advance of any/all replies.
    Don
     
    Mary Gaunt, Jan 18, 2006
    #1
  2. -----------------------------

    :) It's because of your (Canadian) metric speedometer. In America, the
    speedo only shows 65, while yours shows 100 Km/hr. Try driving slightly
    below the speed limit and everything will sound 'zippier'. :)

    I'm pulling your leg, of course. Maybe you're hanging out at Starbucks
    too much, and your body is running too fast?

    'Curly'
     
    'Curly Q. Links', Jan 18, 2006
    #2
  3. Mary  Gaunt

    Bucky Guest

    This is not possible. If the CD was spinning too slowly, it would not
    extend the duration of the music, It would start skipping. CDs are not
    like a record player or tape player. With those analog devices, yes,
    slower speed results in slower music (and lower pitch) and a draggy
    effect.
    I'm sure there is a minimum speed that CDs need to spin, but most CD
    players spin faster for skip protection (by reading ahead and buffering
    data). BTW, CD players do not spin at a constant speed. For the inner
    tracks, it spins faster. For the outer tracks, it spins slower.

    In any case, you cannot change this in the Honda equipment. Most likely
    is the speaker quality or EQ settings making it sound draggy.
     
    Bucky, Jan 18, 2006
    #3
  4. To amplify Bucky's response, it isn't possible for the CD to spin too slowly
    without the music breaking up. What we hear is actually digitized audio
    being read from the CD as the player needs the data, then decoded (the CD
    has a fairly sophisticated coding scheme to prevent scratches from showing
    up as clicks) and sent to the speakers at a very precise rate. What this all
    means is that the difference you hear comes from something other than the
    rate at which the CD spins.

    Mike
     
    Michael Pardee, Jan 19, 2006
    #4
  5. Mary  Gaunt

    Doug McCrary Guest

    What Mike says is true to a point.
    However, it could be that the clock for the digital-to-analog coverter could be
    slow. It would be crystal controlled, and essentially not adjustable. The fix
    would be a new player.
     
    Doug McCrary, Jan 20, 2006
    #5
  6. However, even a really bad crystal is many orders of magnitude better than
    the human ear could discern.

    Mike
     
    Michael Pardee, Jan 20, 2006
    #6
  7. Mary  Gaunt

    Doug McCrary Guest

    Not if it cracked. Anyway, that's all I can think of that would make that much
    difference, unless it's a bad clock divider - in any case, the cost-effective
    solution is to replace, unless you have a lot of equipment and time.

    All of that assumes that it really *is* slow - I wonder if the OP has actually
    timed the length of anything on the suspect player and compared it with a
    "normal" player vs. what the cd says the run time is....
     
    Doug McCrary, Jan 21, 2006
    #7
  8. Cracked crystals are dead crystals - more than 35 years experience with that
    :) I've never seen a working crystal off by enough to hear... maybe .01%.
    Safe to say the actual frequency reproduction is fine, that the problem is
    either output/speaker problems or perception.

    Mike
     
    Michael Pardee, Jan 21, 2006
    #8
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.