cd plays CD-R?

Discussion in 'General Motoring' started by Sanjay, Jul 18, 2004.

  1. Sanjay

    Sanjay Guest

    I just bought a 98 civic and it has the factory installed cd player....
    the problem is...it doesnt play my burned cds....ive read online that
    it could be the CD or the software im using...Im wondering if any1
    else has had this problem, and has found a solution.

    regards,
    sanjay
     
    Sanjay, Jul 18, 2004
    #1
  2. Sanjay

    John Ings Guest

    My 96 Accura plays the CD's I burn using Nero Burning ROM

    http://www.ahead.de/us/index.html
     
    John Ings, Jul 18, 2004
    #2
  3. Sanjay

    SAC 441 Guest

    Obviously your CD Player/Recorder is mismatched because it records using
    a different codec than the one that was installed in the vehicle.I am
    not at all familiar with the different player codec types,but I would
    check to see if your recording/burning unit is MPEG-2,4 or some other
    esoteric scheme I have not personally heard of.If it is different,you
    will either have to replace the unit in the vehicle or use a different
    recorder CD burner that matches the unit in your car.I have heard (not
    personal experience) that some PC based CD burners will not output to
    other playing devices because of copy protection software employed on
    the most recently manufactured units.......ONLY on the primary recording
    device.You might check this possibility out as well.
     
    SAC 441, Jul 18, 2004
    #3
  4. Sanjay

    Gary Guest

    Same problem with my CD player in a 2000 Accord
    Try burning them at 4X and use good CDR's
     
    Gary, Jul 19, 2004
    #4
  5. There are no codecs here if it's a CD-R - it's red book audio with possible
    orange book extensions.

    Rgds, George Macdonald

    "Just because they're paranoid doesn't mean you're not psychotic" - Who, me??
     
    George Macdonald, Jul 19, 2004
    #5
  6. What brand of CD-Rs are you using - there's a lot of junk out there... even
    with well known brand names. I'd suggest you try a different quality brand
    of CD-R, like Taiyo Yuden or Mitsui and use slower record speeds if
    necessary. '98 is a little early for CD-R compatiblity and even if it
    works, you should be warned that it may damage your player by causing it to
    run constantly in error recovery mode.

    Rgds, George Macdonald

    "Just because they're paranoid doesn't mean you're not psychotic" - Who, me??
     
    George Macdonald, Jul 19, 2004
    #6
  7. Sanjay

    JM Guest

    Hey, look ma, a guy on webtv. is giving advice on technical stuff.

    A standard CD player plays CD-Audio, or "red book" standard disks.
    There is no encoding or compression to worry about. Your burner
    software should handle this task easily enough. Some CD players just
    won't handle CD-R, however, becaue the CD-R disks are not as
    reflective as commercial pressed disks are.

    The player may never have been designed with a bright enough laser, or
    a sensitive enough pick-up device. Or, your lens may be a little
    dusty & needs to be cleaned with a commercially available cleaning
    disk that has little brushes. Or, you may have used the player a lot,
    and the brightness of the laser has diminished below acceptable levels
    for playing CD-R, even if it still plays pressed disks.

    Do not try to use CD-RW disks. Hardly any auto player can cope with
    those, due to very low reflectivity.

    Try another brand of CD-R's; you're looking for maximum reflectivity.
    You may also need to burn the disk at a slow speed, which will make
    for more precisely shaped "pits".

    I assume that you've tried your burned disks on another player to make
    sure that they work at all.

    JM
     
    JM, Jul 19, 2004
    #7
  8. Sanjay

    SAC 441 Guest

    I do not claim to be an expert on such matters.But I did have a similar
    experience with a CD player in my Honda Civic.I have an XM Radio
    installed by an independent installer.I have a Pioneer LD/CD-RW unit at
    home.When I tried to play my discs from the home unit on my Honda CD
    player,it did not work.The dealer did not have any idea why it did not
    work,so I took it to the independent installer and asked him why it did
    not.He deals in the same Pioneer audio equipment I use at home;he spent
    an hour doing some "tests" and told me it was mismatched codecs
    (whatever the heck they are) and I could not use the home units disc
    recordings in my Honda.So naturally,I thought it might have been the
    same thing.If you say it is something else,I believe you......
     
    SAC 441, Jul 20, 2004
    #8
  9. Sanjay

    Chris Guest

    I had a 1995 Nissan 240sx that was very finicky about the cds I used. It was
    more about the color than the brand. Blue cds would not play but silver ones
    would.
     
    Chris, Jul 20, 2004
    #9
  10. Sanjay

    Sanjay Guest

    You guys were right!!! I just bought TDK and burned using NERO @ 4x
    and they play wonderfully. No more cheap memorex CDrs for me.

    Thanks
    Sanjay
     
    Sanjay, Jul 20, 2004
    #10
  11. Sanjay

    Tracy Guest

    Make sure you are closing the recording session. Depending on your
    software, you may have to search for this option, and it may use
    different terminology, but you need to finalize the recording so that
    no other data can be added to the disk. Otherwise, it will play on
    your computer (and perhaps others), but not in a car.
     
    Tracy, Jul 20, 2004
    #11
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.