Changing spark plugs in 1991 accord

So I go down to the local parts store and get some new plugs, and then
see how the plugs are mounted *way* down inside the valve cover.

Is there a special tool for changing the plugs? Are you supposed to pull
the cover to do it?

I'd never seen a setup like that before. I guess I need to rummage up
a service manual for the car.

 

If you can't reach it, get an extension. Cool.

 

Is there a special tool for changing the plugs? Are you supposed to pull

You need an extension for your rachet.
Then you should use a spark plug socket. It had a rubber inside that grabs
your plug and allows you to oull it out and put the new one in.

 

You'll need a somewhat thinner spark plug socket wrench than you probably
already have.

Also, get about a 12" length of rubber hose that is just the diameter to slip
over the ribs on the insulator. Perhaps the hose that goes to the transmission
cooler. When you install the new plugs, the rubber hose will be long enough to
reach down the opening, but unlike a socket wrench, you'll prevent
cross-threading by starting the plugs by hand. If you start to cross thread the
hose will act like a clutch and start to slip.
JIMBO

 

jason carr wrote in message ...

I discovered the same thing when I went to change the plugs on my 2000
Civic.
I went back to the local parts store (Kragens) and found a sprak plug wrench
designed for
this setup for less than $3. You could also use a spark plug socket and an
extender on a standard
ratchet but since it was cheap I went ahead and bought the wrench. It has a
swivel on the
socket end which makes it easier to avoid cross threading.

Kevin

 

I'll look for one. Thanks.

jc,
glad it's not a mandatory $50 honda-only tool.