CRV 2003 - Reset Engine Light

Discussion in 'CR-V' started by janeandjohn1232000, Dec 26, 2006.

  1. I got these codes from the diagnostic- P 1166 and P 1456. everything I
    saw meant new gas cap so I have replaced it. But I need to know how to
    reset the Check Engine LIght. I did the Odometer and ignition, but
    that seems only to reset the Maintenence light. Any Help? Could it be
    more than the gas cap? Thanks!
     
    janeandjohn1232000, Dec 26, 2006
    #1
  2. janeandjohn1232000

    Woody Guest

    If the problem is fixed it will go away after a week or so of driving. It
    takes several drive cycles. Sometimes you can reset it by pulling the
    negative battery lead but that can create other problems so I don't
    recommend it unless you know what you are doing. It can be reset with an
    OBDII tester if you have access of one. I recommend you wait a week and see
    if it goes away. If not take it to someone that knows how to test it.
     
    Woody, Dec 26, 2006
    #2
  3. janeandjohn1232000

    Tegger Guest

    wrote in 42g2000cwt.googlegroups.com:


    P1166 is your A/F Sensor heater circuit, unrelated to the EVAP.

    Did you know you have at least one TSB regarding the P1456 error? It's
    04-002. The fix involves replacing the fuel fill pipe, which is defective.

    Make haste to your local dealer! This may still be covered under warranty.
     
    Tegger, Dec 26, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.