CRX quarter window/glass gasket/moulding

Discussion in 'General Motoring' started by Meatman, Mar 6, 2008.

  1. Meatman

    Meatman Guest

    88CRX DX. Does the exterior trim moulding/gasket run ALL the way
    around and butt directly into the vertical piece on the would-be B-
    pillar? Or is there supposed to be a 1.5-2" horiz gap at the top
    between the vert piece and where the window trim piece starts? Both
    sides of mine are like this. thanks.

    Kevin
     
    Meatman, Mar 6, 2008
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Popping a dent on quarter panel

  2. 90 Civic sedan"winshield moulding removal"

  3. Passenger side power window glass goes down only few inches...

  4. Replacement Glass ? Giant Glass: Opinions On ?

  5. Best way to remove plastic window stickers from glass?

  6. Instructions for removing front quarter panel on 91 Accord

  7. Window Film-Glass Cleaners

  8. Replacement Glass ? Giant Glass: Opinions On ?

Loading...