EGR problems on '87 Accord

Discussion in 'Accord' started by Dean Carriveau, Oct 7, 2008.

  1. Hi,

    I have an '87 Accord DX with carb fuel. My problem is rough running and
    lack of power after the engine warms and drops to normal idle RPM (about 700
    rpm). It has poor power getting under way or climbing hills from this
    point. The problem appears to be intermittant as well. When I remove the
    vacuum hose from the EGR valve, the car runs and idles normally. I replaced
    the EGR ($200!) and it didn't solve the problem. My manual says that the
    EGR control valve A and B could be causing the EGR valve to operate when it
    shouldn't. I have not been able to find these and guess they are in the ECU
    on the firewall. Is this correct? I took the lid off and looked inside
    the box and it looked pretty scary. Has anyone had a similar problem and
    is there a drawing (or picture) of the A and B EGR control valves available?
    I'm planning to go to a wrecker this weekend to see if I can find a used
    box. Could a bad oxygen sensor cause this problem?

    Thanks in advance.
    Dean Carriveau
     
    Dean Carriveau, Oct 7, 2008
    #1
  2. Dean Carriveau

    Jim Yanik Guest

    it's not the ECU.
    And if the O2S were bad,it would not run "normally" with the EGR hose
    disconnected.
    maybe you have a cracked hose or a plugged hose?

    Also pay attention to coolant levels in the radiator,not just looking at
    the reservoir tank.The coolant temp sensor has to be immersed for it to
    work right. there may be a air bleed port on your motor,that you open when
    the engine is fully warmed up and bleed out any air.

    Is there a diagram of the EGR system on the hood of your car?
     
    Jim Yanik, Oct 7, 2008
    #2
  3. Dean Carriveau

    TE Chea Guest

    is there a drawing (or picture) of the A and B EGR control valves available?
    see Autozone repair guide
     
    TE Chea, Oct 8, 2008
    #3
  4. Dean Carriveau

    Woody Guest

    Changing the EGR doesn't do any good if the ports to the valve are blocked.
    You only did half the job.
     
    Woody, Oct 10, 2008
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.