Fuel Injector code

Discussion in 'General Motoring' started by DD, Oct 9, 2005.

  1. DD

    DD Guest

    I have a 1991 CRX w/1.5L dual-port engine. Just put in a new block. Haven't
    been able to get it to start. Keep getting a code 16 (injector code).
    Checked the resistance on the injectors like the book says. They check out
    OK. Even tried putting in a couple of other ones that I had. Still get the
    code. Checked the main relay, it's OK also. Anybody got any ideas? Thanks.
     
    DD, Oct 9, 2005
    #1
  2. DD

    jim beam Guest

    it /is/ the main relay. unfortunately, it's an intermittent fault, so
    just because you tested it a couple of times and it shows ok, doesn't
    mean it's not the fault. pull the relay and either resolder or replace.
    go to tegger.com and check out his section on relay repair & replacement.
     
    jim beam, Oct 9, 2005
    #2
  3. DD

    DD Guest

    Thanks for the help. It wasn't the relay. I went to tegger.com to research
    it like you said. It was a stupid ground wire near the thermostat that comes
    from the ecu that didn't get attached. Hooked it up and it cranked
    immediately. Sure would have been nice to know a week ago. But better late
    than never.
     
    DD, Oct 10, 2005
    #3
  4. DD

    jim beam Guest

    ok, glad you got it fixed! gotta say, tegger's diagnostics on that
    relay thing are /way/ better than any manual!
     
    jim beam, Oct 10, 2005
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.