headlight

Discussion in 'General Motoring' started by froglewis, Feb 16, 2004.

  1. froglewis

    froglewis Guest

    hi guys - i have a problem with my headlight in that its got condensation
    inside it. I checked it out and the weather seal wasnt connected fully -
    this has now been rectified, but does anyone know how i get rid of the
    condensation? any help much appreciated

    cheers
     
    froglewis, Feb 16, 2004
    #1
  2. Use a hair dryer.


     
    Bradley D. Allison, Feb 16, 2004
    #2
  3. froglewis

    froglewis Guest

    Does that work or are you 'yanking my chain'?!?

    =---
     
    froglewis, Feb 16, 2004
    #3
  4. froglewis

    Tomas Guest

    Park the car so that it's pointing towards the sun, then remove the bulb
    from the headlight housing. You could use an infra-red type heater, but be
    careful as not to melt the housing.
     
    Tomas, Feb 17, 2004
    #4
  5. froglewis

    Bebop Guest

    Works, but once condensation appears in the housing. It will keep
    reappearing if not sealed properly.

    Or use a very long Q-tip.
     
    Bebop, Feb 17, 2004
    #5
  6. =============

    frog,

    If you remember chemistry class, you'll recognize that the headlight
    assembly is the same basic design as the Earlenmyer (sp) flask, which
    was designed to prevent the contents from evaporating. You're going to
    need to either force dry air in, or suck moist air out. If you have an
    aquarium air pump or access to an air hose, you've got it made.

    Don't go poking anything inside there like a rag, because it's a primary
    surface mirror in there. The coating is on the near side, (just like
    inside photocopiers and fax machined) and it scratches VERY easily. Your
    bathroom mirror has the reflective coating on the backside, where you
    can't harm it.

    'Curly'

    ==============
     
    'Curly Q. Links', Feb 17, 2004
    #6
  7. froglewis

    froglewis Guest

    cheers guys - i dont have any thing like that, but i have a hair dryer!

    cheers again
     
    froglewis, Feb 17, 2004
    #7
  8. froglewis

    Bob W. Guest

    Get a pair of hemostats and ball up a small piece of paper towel.
    Clamp the ball of paper towel into the hemostats and dab the inside of
    the lens.
     
    Bob W., Feb 18, 2004
    #8
  9. froglewis

    Jawshhh20 Guest

    If you can't fix the problem using those methods, you might consider replacing
    your lenses either through your local dealer or by checking your local wrecking
    yard for one of a totaled car. Wrecking yards are a lot cheaper anyway.


    J Hebert
     
    Jawshhh20, Feb 18, 2004
    #9
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.