help with troubleshooting (blown head gasket, or clogged pcv valve?)

Discussion in 'General Motoring' started by Phil, Jan 24, 2007.

  1. Phil

    Phil Guest

    I have a 99 honda civic with a d16Y8 sohc engine with vtec (its actually an
    acura 1.6 el, but for simplicitys sake, we'll call it a civic since its the
    same thing). and I have milky tan\white colour stuff (gunk i guess), in the
    head (under the valve cover). This is a symptom of a head gasket leak going
    from the coolant to the oil, but I dont seem to have many of the other
    common symptoms!

    here is a list I made of what i know

    -thick tan coloured residue in the head
    -oil looks normal on dip stick
    -engine is not overheating
    -the engine runs and idles normally
    -the engine hasn't lost power
    -spark plugs appear normal (somebody compared the plugs from there intega to
    mine)
    -cant smell coolant in exhaust gases (at least I cant)
    -no bubbles in coolant resivoir with the engine running (should I check in
    the rad cap with the engine running?)
    -looks like there's oil in the coolant but the coolant is not milky, its
    bright green. however, when I take the overflow hose out of the resivoir,
    coolant drips out of the hose and when it hits the coolant in the resivoir,
    i can see a little bit of black liquid which dissolves into the coolant (is
    this oil?)
    -the exhaust dosent look too white (from burning coolant), but it IS winter,
    so it might be hard to tell
    -The coolant level dosent seem to be going down (if it is, its too slow to
    tell after just a few short trips)
    -my PCV valve could be clogged, I dont really know (which would cause
    condensation in the block\head, leading to the residue in the head), but
    given that it looks like there is oil in the coolant, Ii think this is
    probably less likely the problem.

    What do you think, is any further testing nessecary? I would like to stay
    away from spending money on any testing equipment if possible, but basically
    the only two problems seem to be blown head gasket, or clogged pcv valve..
    and i guess a possibility of a badly warped or cracked head.

    thanks in advance

    Phil
     
    Phil, Jan 24, 2007
    #1
  2. Phil

    Phil Guest

    I should mention that i have 140,000 km on the engine, and have never had to
    pull the head for anything before.
     
    Phil, Jan 24, 2007
    #2
  3. Phil

    motsco_ Guest

    ===========================================

    It sounds like one of two or three things: You're warming it up on the
    driveway, you're only driving five blocks to work, your PCV needs changing.

    'Curly'
     
    motsco_, Jan 25, 2007
    #3
  4. Phil

    jim beam Guest

    if the head was "badly warped or cracked", it wouldn't be drivable.
    yes, mayonnaise under the oil cap is a symptom of head gasket, but
    usually it's a /lot/ of mayonnaise, not a little. a little is not
    getting the motor hot enough like curly says. check/replace pcv and
    keep driving until "symptoms" get worse. do /not/ warm up engine on
    driveway.
     
    jim beam, Jan 25, 2007
    #4
  5. Phil

    BT Guest

    Why is this a bad thing? Just curious.

    Thanks,
    BT
     
    BT, Jan 25, 2007
    #5
  6. Phil

    Phil Guest

    turns out it was just an overdue oil change and the short trips thing. i
    dont warm it up on the driveway, i know you only let it idle for max 1
    minute before you drive it, but thanks for the heads up. the problem has
    cleared up completely just from driving it.
     
    Phil, Jan 31, 2007
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.