Hi everybody...help please.

Discussion in 'General Motoring' started by TMW, Dec 1, 2006.

  1. TMW

    TMW Guest

    Hi, I have a ’97 Honda Accord with about 75,000 miles. It has a
    problem with its giddy-up. It has to work awfully hard to get to even
    35 mph. It seems that after driving it for a while and letting it warm
    up, its a "little better". Anyone know what the problem would be?
    And more importantly, how much I can expect to pay to get it fixed?
     
    TMW, Dec 1, 2006
    #1
  2. TMW

    Speedy Pete Guest

    Start with a leakdown test. Its the BEST way to find out the condition
    of your motor AND if it does have internal problems they can be found
    with a little listening.

    AFter that you can start changing parts.

    -Speedy
     
    Speedy Pete, Dec 1, 2006
    #2
  3. TMW

    Elle Guest

    When was the last tuneup (new plugs, ignition wires,
    distributor cap and rotor, timing check, fuel filter, air
    filter, bottle of Chevron Techron in the fuel tank)? Were
    OEM ignition parts used?

    Cooling system topped off?
     
    Elle, Dec 1, 2006
    #3
  4. TMW

    jim beam Guest

    /start/ leak-down on a vehicle with only 75k? /much/ more likely to be
    maintenance issue - or timing belt slippage.
    don't change a thing until you know /what/ the problem is! go to
    tegger.com and read the faq's to start, then buy the honda manual from
    helm.com. full diagnostics are in there, including reading error codes
    from the ecu.
     
    jim beam, Dec 1, 2006
    #4
  5. TMW

    Woody Guest

    Might start by making sure it is firing on all 4 cylinders. My daughters
    lost half the coilpack and ran smooth on two cylinders. Only problem was it
    would only do about 40mph. It also killed the converter.
     
    Woody, Dec 1, 2006
    #5
  6. Besides the other good answers, it is possible your catalytic converter is
    plugged. A test for that (from a Haynes manual, believe it or don't) is done
    with a manifold pressure guage. Watch the guage at idle and note the
    reading. Rev the engine to about 2000 rpm for a few seconds, then watch the
    guage when you release the throttle. It should drop to the idle reading (or
    close to it) within two seconds. If it hangs at the high reading or only
    gradually returns to the idle reading suspect an exhaust restriction.

    Mike
     
    Michael Pardee, Dec 2, 2006
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.