high beam works but low beam doesnt

Discussion in 'General Motoring' started by toolowcivic, Jan 27, 2007.

  1. toolowcivic

    toolowcivic Guest

    I have a 2001 civic ex coupe. Both of my low beams just went out.
    The high beam works fine. All fuses have been checked and there all
    good. When I switch to turn on my low beams I here a clicking noise
    under the hood. I had antoher h4 bulb and I tried it to see if it
    would work and its the same thing. Is it possible for both lights to
    be bad or is it some wiring issue? I need to get this fixed asap.
     
    toolowcivic, Jan 27, 2007
    #1
  2. toolowcivic

    Skyhawk Guest

    My Insight had the same problem. Turned out to be a bad pin at the switch
    in the steering column. There was a recall on it !!!!!! Check with your
    dealer. It cost $300 for diagnostic time to find the problem before they
    knew about the pin recall! They did such a terrible job I got my money
    back, but that's another story.
    Good luck...
     
    Skyhawk, Jan 27, 2007
    #2
  3. toolowcivic

    laxman Guest

    I am experiencing the very same problem right now, any solution to
    this problem?
     
    laxman, Jan 28, 2007
    #3
  4. toolowcivic

    thorpey Guest

    Just had the same thing on my CR-V and both bulbs had gone u/s, mind
    you if there is a clicking noise, there could be a chance a relay has
    packed up.
     
    thorpey, Jan 28, 2007
    #4
  5. toolowcivic

    rammy121 Guest

    i had the same problem with a horrid volvo 340 (YUKK!!!). turned out
    to be the relay too.

    rammy (u.k.)
     
    rammy121, Mar 2, 2007
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.