I love my 1991 Accord

Discussion in 'Accord' started by Mark G., Mar 22, 2010.

  1. Mark G.

    Mark G. Guest

    200k miles, going for 300k...
     
    Mark G., Mar 22, 2010
    #1
  2. Don't forget to replace that timing belt!
     
    Question Quigley, Mar 22, 2010
    #2
  3. Mark G.

    TE Cheah Guest

    Possible only in a cold climate ( for which SM4 is optimised ), needs to
    be modified for a warm ( let alone hot ) climate, or every component (
    esp injectors / alternator ) below bonnet will be too hot, e.g. resistors'
    heat ( 19.86 watt ) will flow toward injectors which when idle & hot
    will evaporate petrol, then petrol's wax content will clog nozzles, then
    engine will be hard to start [ii] detergent added by user can't
    dissolve all of this wax ( accumulate too fast ) in city use.
    Thermostat opens @78ºC i.e. this is ideal tmprtre, but tmprtre gauge
    has no calibration, to hide overheating in a warm/ hot climate.
    2.2 litre has longer branch exhaust*manifold, 2 litre has cheapo short
    branch *. Results lower though adequate torque @ low rpm ( as
    during buyers' test drives ), but very low ( <½ as much ) torque & mpg
    @ high ( >3000 ) rpm : inadequacy increases with rpm. [ii] on highway
    when >3000 rpm is needed, user cannot change gear from neutral to
    drive w-o a jerk ; crank shaft etc. cannot spin fast enough from idle to >
    3000 rpm [iii] cooling is worse. This is why expensive cars have long
    branch *. http://circletrack.com/techarticles/73598
    Many car makers ( incl Nissan in Sunny 130Y, Hyundai in Sonata 2.4,
    Proton in Waja 1.8 ) save on *, because 99.9% buyers have no chance
    to test drive on highways, or know / experienced a difference between
    short & long branch *. Honda fits only short branch ( 4 into 1 pipe ),
    cheap & heavy cast iron * for its engines <2.2 litre.
    Toe-in prescribed for rear wheels is stupid ; rolling resistance is not
    minimised ( & fuel consumption maximised ) unless toe-in is 0.
    Disc brake calipers' mounting bolts must not be overtightened, or pads
    when idle will bind discs : I had to add a spring washer to avoid over
    tightening.

    | 200k miles, going for 300k...
    Gearbox lacks a ATF filter, torque convertor's lock up clutch won't lock
    , before 100k miles unless a filter is fitted. Changing ATF can't remove
    all dirt : my 2nd g-box was noisy in neutral despite ATF change, before
    a filter was fitted & used for 3000 km.
     
    TE Cheah, Mar 23, 2010
    #3
  4. Mark G.

    TE Cheah Guest

    | ( & fuel consumption maximised )
     
    TE Cheah, Mar 24, 2010
    #4
  5. Mark G.

    thomas Guest

    do you think he needs an answer?
     
    thomas, Mar 24, 2010
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.