Jumpering ECU 93 Civic 1.6L

Discussion in 'Civic' started by yetterchris, Oct 30, 2006.

  1. yetterchris

    yetterchris Guest

    I just replaced the distributor due to failed bearing. The engine runs
    okay but has a slight ping under acceleration. I want to check/adjust
    the timing and need to know exactly how to jumper the ecu. I've found
    the marks for setting timing and have my timing light ready, now I just
    need to know how to jumper the ecu. Thanks in advance.
     
    yetterchris, Oct 30, 2006
    #1
  2. yetterchris

    TeGGeR® Guest

    wrote in @h48g2000cwc.googlegroups.com:

    The Service Check Connector is a blue 2-pin plastic thing. It's at the top
    of the passenger kick panel, just ahead of the door. You might have to fish
    around at the top of the kick panel before you find it.

    Bend up a paper clip and use that to short the terminals together, then
    start the car and adjust the timing. The engine MUST be fully warm!

    The MIDDLE of the group of three should line up with the timing belt cover
    mark when the timing's set correctly.

    Don't forget to remove the jumper when done.
     
    TeGGeR®, Oct 30, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. follow up to my 1989 Honda Civic DX Sedan TDC Sensor/ECU Problem.

  2. Reset 2005 Civic ECU

  3. how to test ECU on Honda Civic '89

  4. 99-00 civic ecu a/t pinouts?

  5. 1990 Civic ECU codes

  6. bad ecu on 91 Civic :(

  7. CRX ECU solders cracked? Also ECU v ELD charge problem.

Loading...