Leaking water into trunk

Discussion in 'General Motoring' started by piperspost, Nov 29, 2006.

  1. piperspost

    piperspost Guest

    I am getting water leaking into my trunk everytime it rains, etc.... I
    think it's coming in the taillights. Any suggestions on how to solve
    this
     
    piperspost, Nov 29, 2006
    #1
  2. piperspost

    Tegger Guest

    wrote in 3331.bay.webtv.net:


    Replace the taillight gaskets. Easy and cheap.

    Problem is threefold:
    1) water runs down the rain gutter on either side of the trunk/hatch,
    right on top of the taillights, and
    2) the nuts holding the taillights sometimes come loose, and
    3) the gaskets themselves deteriorate over time

    The gaskets are about 3/8" thick, and are soft foam rubber. they compress
    to near nothing once installed.

    Some will suggest siliconing the taillights on. I strongly un-recommend
    this approach unless there is significant rust under the gasket.

    Don't overtighten the nuts when installing the new gaskets! The last thing
    you want to do is break the stud out of the plastic lamp housing.
     
    Tegger, Nov 29, 2006
    #2
  3. piperspost

    Elle Guest

    One solution: Disassemble all taillight assemblies. Remove
    old gaskets. Clean thoroughly with water. Let dry. Apply
    weather appropriate caulking from your local hardware store
    to both sides of the gaskets. Re-assemble. I did this about
    four years ago with my 91 Civic. No leaks since.

    You can buy new gaskets and get the same effect as well. The
    advantage is that, if the gaskets leak again, you don't have
    that nasty caulking to scrape off the car metal.
     
    Elle, Nov 29, 2006
    #3
  4. piperspost

    .... Guest

    Is it an Accord?
    Look in taillights after or during a rain, they may be filling up with
    water. If the gasket gets old the groove under the trunk pours water into
    the light, when it gets half full it spills into the trunk.

    I took out the light and sealed it with a bead of silicone. I caulked
    that body seam to encourage water to go away from the light. Then for
    insurance I drilled a 1/32nd hole or two in the bottom of the lens where
    the water pooled. Worked for me.
     
    ...., Apr 30, 2007
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.