So how do I get the rotor screw out?

Discussion in 'General Motoring' started by jack benny, Sep 7, 2008.

  1. jack benny

    jack benny Guest

    95 Accord 4 cyl., replaced cap but can't get to screw outta the rotor
    to replace it.

    Any suggestions on how to do it safely?
     
    jack benny, Sep 7, 2008
    #1
  2. jack benny

    Forrest Guest

    How about getting an impact screw driver? One of those puppies that you hit
    with a hammer. It's held in tightly and turns the screw when you hit it.
     
    Forrest, Sep 8, 2008
    #2
  3. jack benny

    Forrest Guest

    Wait a minute ... I guess my bad. I thought you were talking about the
    small screws that hold the brake rotor on. Just reread your question and saw
    "cap".
     
    Forrest, Sep 8, 2008
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. brake service 98 isuzu rodeo 2WD. Do I have to re-surface the rotor for replacing the brake pad.

  2. How do you get a Title to the Car when......

  3. 1991 Honda Civic - Can’t get the key out of the ignition

  4. Where to get the "H" emblem on the rear of the trunk on Honda Civic LX

  5. how to get bolt out from civic alternator?

  6. 99' Accord Brake Squeak - just replaced brakes, rotor and rotor again

  7. 1999 civic ex 5 speed. need to get stock cd player out....how do you do it?

  8. Car won't start. I think the distributor rotor and crankshaft are out of alignment

Loading...