Spoiler LED Wire type

Discussion in 'General Motoring' started by Guest, Jan 12, 2007.

Page 2 of 2
  1. Guest

    Michael Pardee Guest

    Before giving up, inspect every place the wire goes through tight spots,
    either in metal or with the ground wire along with it. Pinched wires are
    common sources of shorts.

    Mike
     
    Michael Pardee, Jan 15, 2007
    #21
  2. Guest

    Guest Guest

    --
    This post is Sponsored by: www.overheadsoft.com

    http://www.linkreferral.com/cgi-bin/linkreferal/adwel.cgi?oldrefid=20013
    Oh? I did do the plastic tie things all over. Maybe I put them on too
    tightly? The rubber grommet that the wire goes through was not exactly
    clear. I assumed that since it was rubber, it should no harm.
     
    Guest, Jan 16, 2007
    #22
  3. Guest

    Michael Pardee Guest

    If the wire is soft, the ties really could be too tight. Carefully cut them
    and check it out again. The grommet should be okay.

    Mike
     
    Michael Pardee, Jan 16, 2007
    #23
Page 2 of 2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. FS: 2001 Civic DX. Silver, tinted, w/spoiler, alarm+keyless entry...

  2. 1994 Civic HB, rear spoiler / spoiler frame separation

  3. About LED indicators and tail-lights

  4. Neon led

  5. ******LED Motorcycle Lighting******

  6. LED headlights

  7. Civic LX 97, LED on the RADIO, what is it?

  8. AC Panel LED Lights out on Honda Accord 2000.

Loading...