SRS warning light on 2002 Honda Civic EX

Discussion in 'Civic' started by CrossfaceWalls, Jan 27, 2007.

  1. I just purchased a 2002 Honda Civic EX with 33,000 miles on it. I
    bought it from a non-Honda dealer, but as they were doing the
    inspection to update me for two years, they realized the seat belt had
    a problem and the SRS light was on. They had me bring it to the nearest
    Honda dealer to fix the belt free of charge, but when it was over, the
    light was still on and now they tell me they need to replace the chip
    that tells the computer to shut the light off. I'm going back next week
    when the part comes in. The counter person at the service desk told me
    it was covered, but I wasn't assured because she didn't seem very on
    the ball, and I've heard that the computer and lights associated with
    the SRS system don't fall under the "lifetime seat belt warranty".

    I'm gearing up for a fight as I've already paid enough for the car that
    it should be able to pass inspection without me sinking another $100 to
    $300 dollars into it, and this is a KNOWN problem with these
    cars.......but if anyone else can just assure me that you've had this
    issue and the Honda dealer won't give me a hard time just because I
    didn't buy it with them....
     
    CrossfaceWalls, Jan 27, 2007
    #1
  2. CrossfaceWalls

    Tegger Guest



    There's at least one TSB for the SRS system for your car (02-034).

    What were the _specific_ error codes the dealer recorded?

    Did the dealer check for any other TSBs?
     
    Tegger, Jan 27, 2007
    #2
  3. CrossfaceWalls

    Tegger Guest



    There's at least one TSB for the SRS system for your car (02-034).

    What were the _specific_ error codes the dealer recorded?

    Did the dealer check for any other TSBs?
     
    Tegger, Jan 27, 2007
    #3
  4. CrossfaceWalls

    TomP Guest

    Without the SRS DTC, this conversation is pointless.
    --
    Tp,

    -------- __o
    ----- -\<. -------- __o
    --- ( )/ ( ) ---- -\<.
    -------------------- ( )/ ( )
     
    TomP, Jan 27, 2007
    #4
  5. CrossfaceWalls

    TomP Guest

    Without the SRS DTC, this conversation is pointless.
    --
    Tp,

    -------- __o
    ----- -\<. -------- __o
    --- ( )/ ( ) ---- -\<.
    -------------------- ( )/ ( )
     
    TomP, Jan 27, 2007
    #5
  6. CrossfaceWalls

    G-Man Guest

    Okay, on mine and my car-pool partners 2001 accord, same problem. SRS light
    on. Found out it was a seatbelt on both. Dealer said it wasn't covered. I
    paid for a different mechanic to replace. I find out 8 months later that
    they are supposed to replace it free. I contacted Honda and both of us
    received a check for the repair from Honda!

    BTW, there is a plug and a reset procedure to turn the light off. It throws
    NO codes on an OBD II. Nor can it be reset with it.

    Here is the procedure I used to reset it:

    1st you need to either buy or make the "SCS Service Connector." I used a
    speaker harness for and older Honda which you can buy at a local stereo shop
    such as Circuit City or Best Buy, and cut the wires and looped them
    together. You can also use a paperclip but that will make it a little more
    difficult because you have to connect it and disconnect it a few times
    quickly.



    2nd you need to find the MES (Memory Erase Signal) connector.

    It is a yellow connector with two wires in it that is plugged into the fuse
    box, unplug it and pull it down. Once you have done that you can begin the
    process of erasing the memory. NOTE: This will only reset your SRS System if
    what caused it to trigger has been fixed, Ex: turning the ignition on with
    any SRS Plugs disconnected, such as pulling your seat out.



    1.. Turn the ignition off and connect the SCS Service connector to the MES
    Plug,


    2.. Turn Ignition on. SRS indicator light will come on for about 6 seconds
    then go off.


    3.. Disconnect SCS service connector for MES connector within 4 seconds
    after SRS indicator light goes off. SRS indicator light will come on again.


    4.. Reconnect SCS service connector the MES connector within 4 seconds
    after SRS light comes on. SRS indicator light will go off.


    5.. Disconnect SCS service connector from MES connector within 4 seconds.
    SRS indicator light will indicate that memory is erased by blinking 2 times.


    6.. Turn ignition off, and wait 10 seconds. Start vehicle like normal and
    light should come on and go out like normal. You have reset your SRS light,
    congrats.


    If it does not work the first time try it again, the timing has to be
    perfect. It worked for me the 1st time using a paper clip on my 96 del sol.
    Remember if u do it right it will blink two times and then go off.


    G-Man
     
    G-Man, Jan 28, 2007
    #6
  7. CrossfaceWalls

    G-Man Guest

    Okay, on mine and my car-pool partners 2001 accord, same problem. SRS light
    on. Found out it was a seatbelt on both. Dealer said it wasn't covered. I
    paid for a different mechanic to replace. I find out 8 months later that
    they are supposed to replace it free. I contacted Honda and both of us
    received a check for the repair from Honda!

    BTW, there is a plug and a reset procedure to turn the light off. It throws
    NO codes on an OBD II. Nor can it be reset with it.

    Here is the procedure I used to reset it:

    1st you need to either buy or make the "SCS Service Connector." I used a
    speaker harness for and older Honda which you can buy at a local stereo shop
    such as Circuit City or Best Buy, and cut the wires and looped them
    together. You can also use a paperclip but that will make it a little more
    difficult because you have to connect it and disconnect it a few times
    quickly.



    2nd you need to find the MES (Memory Erase Signal) connector.

    It is a yellow connector with two wires in it that is plugged into the fuse
    box, unplug it and pull it down. Once you have done that you can begin the
    process of erasing the memory. NOTE: This will only reset your SRS System if
    what caused it to trigger has been fixed, Ex: turning the ignition on with
    any SRS Plugs disconnected, such as pulling your seat out.



    1.. Turn the ignition off and connect the SCS Service connector to the MES
    Plug,


    2.. Turn Ignition on. SRS indicator light will come on for about 6 seconds
    then go off.


    3.. Disconnect SCS service connector for MES connector within 4 seconds
    after SRS indicator light goes off. SRS indicator light will come on again.


    4.. Reconnect SCS service connector the MES connector within 4 seconds
    after SRS light comes on. SRS indicator light will go off.


    5.. Disconnect SCS service connector from MES connector within 4 seconds.
    SRS indicator light will indicate that memory is erased by blinking 2 times.


    6.. Turn ignition off, and wait 10 seconds. Start vehicle like normal and
    light should come on and go out like normal. You have reset your SRS light,
    congrats.


    If it does not work the first time try it again, the timing has to be
    perfect. It worked for me the 1st time using a paper clip on my 96 del sol.
    Remember if u do it right it will blink two times and then go off.


    G-Man
     
    G-Man, Jan 28, 2007
    #7

  8. Well, it was all fixed, no questions asked, although I guess that had
    as much to do with the other dealer looking to complete the sale
    smoothly.
     
    CrossfaceWalls, Jan 30, 2007
    #8
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.